Joined: 07 Sep 2011
Location: Montreal, Qc, Canada
|Posted: Wed Oct 04, 2017 8:41 pm
In Workbench, for a Steady State Thermal Analysis, more than 300 Convection BCs need to be applied on various surfaces. For each of these surfaces, a Named Selection was created (very helpful when setuping the model).
However, the following Warning message appears during solving: "Not all Named Selections were successfully written because one or more names are not valid for the solver". Got this warning with both the direct (Sparse) and iterative (PCG) solvers.
Does any know where those name restrictions could be found?
I restrict my naming convention with alphabetic and numeric characters, dash "-" and underscore "_" such as VA, BH_1, FH-1, etc.
Ecole de Technologie Superieure
Montreal, Quebec, Canada