Joined: 21 Oct 2008
|Posted: Tue Oct 27, 2009 12:15 am
I am using ansys (V11) batch mode solver. While solving in batch mode i have to access geometry details.
If i try to access there was error because geometry details were not transferred. Only keypoints , element , nodes were transferred.
For example i have to use commands ASEL , AGEN , APLOT.... ( FOR AN DYNAMIC ANALYSIS with in *do loop. ).
please suggest a solution.
LARSEN AND TOUBRO LIMITED
Larsen & Toubro Limited
Electrical & Electronics Division - EBG
This E-mail may contain confidential or privileged information for the intended recipient(s). If you are not the intended recipient, please do not use or disseminate the information, notify the sender and delete it from your system.
Post generated using Mail2Forum (http://www.mail2forum.com)