Joined: 06 Mar 2012
Location: Columbus, OH
|Posted: Tue Jun 30, 2015 8:52 am
|Using Mechanical V16.1, Windows 7 on a Dell M4800 with AMD FirePro M5100. I'm using "switchable graphics" where the computer uses the built-in Intel graphics chip for most applications, only running the AMD graphics chip when needed. I've manually configured the AMD Catalyst Control Center such that ansyswbu.exe gets run on the AMD graphics chip. The AMD graphics monitor confirms that Mechanical is running on the AMD graphics chip.
When I zoom in on the mesh to see fine details, the mesh disappears.
Sometimes when I'm looking a zoomed in result and toggle "Show Elements", they don't show unless I zoom out.
Intel and AMD graphics drivers are all up-to-date.
Anyone have a clue if this is an issue with Mechanical, the FirePro M5100, switchable graphics, etc?
Andrew C. Kelly, P.E.
Honeywell Sensing & Productivity Solutions