Joined: 29 Oct 2014
|Posted: Sun Aug 02, 2015 1:28 pm
i am using SOLID186 with mixed formulation. i cool my model from 200 to 25°c.
tref for 200 and bfe for cooling it down to 25 in 1st load step.
i would like to read out the temp at few nodes at every substep. i tried using *get command.
both the commands but neither worked. it would be great if anybody could help.
after the 1st load step i kill the elements of a volume. and everything works fine.
but when i issue plnsol command , the volume is also being showed which i dont want .
i tried unselecting the volume and using replot command but when i use vplot then only that volume is not shown.
i dont want that volume to been shown during post processing.
student tu chemnitz